Now exit Hyperterminal and remove the USB modem. This tells the modem not to use CD mode when it is first plugged into a computer. Once connected, type the following commands: Connect to that COM port through Hyperterminal, found in the Accessories area of the Start Menu. Under the Ports section, find the COM port that's connected to the USB modem (ignore the Diagnostics mode). Once done, close the Rogers app that starts up, then head into the Device Manager ( Control Panel > System > Hardware > Device Manager). Using a Windows machine, plug in the USB device and go through the short install wizard. It is also known as the Rogers (Canadian cellular carrier) red stick USB dongle.Ĭonfiguration Disable CD mode on the device It can send data at speeds up to 4.5 Mbps on 3G+ networks and receive data at speeds of up to 7.2 Mbps. It has an integrated micro-SD card reader. then you'll need to phone the Customer services and have it removed.The ZTE MF626 / MF636 is a USB modem which combines 3G+/3G with EDGE/GPRS in one compact device. If you find you can't access gambling sites etc. I've also not yet tested whether the dongles ship with 'child protection' enabled by default, I know their phones do. The dongle can send and receive text messages, and there's probably a way to do this from Linux, but I haven't delved quite that far just yet. You should now be able to use your 3G mobile broadband dongle to your hearts (or your wallets) content. There are a couple more details which you are likely to need, these are: I personally prefer Wvdial, but most will do. You can then configure your network/dial up manager as you would any other modem. You should then receive a response containing 0:Fail 1:Success Once this has happened enter the following, followed by enter (you may wish to press Ctrl-A then Z and turn local echo on so you can see what you are typing!) Set the serial port itself to /dev/ttyUSB0Īt this stage you should see minicom initialise the modem (an AT command will crawl across the screen). Select Serial Port Setup and change settings to: Make sure you have minicom installed (a sort of CLI version of Windows Hyperterminal) So lets tell the thing that we don't want its crappy CDROM emulation. So your modem has now been detected, but if you unplug it, you'll have to run usb_modeswitch again to change it back to a modem. If this fails then you need to compile the module for your kernel (which is way off on a tangent for this article!) If it hasn't then try running (as root) modprobe option. If you run dmesg now you should see that the system has detected the modem. usr/sbin/usb_modeswitch -W -c /etc/usb_nf Now to change the dongle to a modem use su to become root and run the following command. Run lsusb and you should see the Vendor ID 0x19d2 listed alongside product ID 0x2000. Now plug in your dongle and wait a few seconds, run dmesg and you should see the faux CDROM being detected. Save the file and exit nano (Ctrl-o then Ctrl-x) Obviously if you are running a *ubuntu you'll use sudo instead of su. If you're a true soldier and went for option 3, then let's begin. If you chose option 2 then install the software on Windows and use it to turn off the CDROM mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |